Zenith ZP505 Manual do Utilizador descarregar pdf (Página 5)

Setup, cont.

Write your codes down here for easy reference later.

Code Search

If your product does not respond after you have tried all

the codes for your brand, or if your brand is not listed,

try searching for your code by following these steps.

1. Manually turn on the device (TV, VCR, etc.) to be

controlled.

2. Press and hold the CODE SEARCH button until the

red indicator stays on, then release the CODE

SEARCH button.

3. Press and quickly release the desired mode button

(TV, VCR, etc.). The red indicator blinks off once.

4. Press the CHANNEL UP button repeatedly (up to

300 times) until the device to be controlled changes

channel. The red indicator blinks off with each

button press. If you accidentally overshoot the code

required, press the CHANNEL DOWN button to

backtrack through the library until the device

changes channel. Pressing CHANNEL UP changes

direction to forward again.

5. Press and release MUTE to install the code.

Setup

Battery Installation

1. On the back of the remote, push down on the tab

and lift the cover off.

2. Match the batteries to the + and - marks inside the

battery case, then insert 2 AAA Alkaline batteries.

3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons are

depressed more than 30 seconds.

Code Saver

You will have up to 10 minutes to change the batteries

in your remote without losing codes you have

programmed. However, do not press any buttons until

batteries are installed in the remote. If buttons are

pressed without batteries in the remote, all codes will be

lost.

Direct Code Entry

NOTE: You can store any kind of code under any mode

(except TV). I.E. you can store a VCR code under the

CBL button, or a DVD code under the VCR button, etc.

However, you can only store TV codes under the TV

button.

1. Press and hold the CODE SEARCH button until the

red indicator stays on, then release the CODE

SEARCH button.

2. Press and release the desired mode button (TV,

VCR, etc.). The red indicator blinks, then stays lit.

3. Enter the 4 digit code from the code tables (on

separate sheet). Note: after a valid code entry, the

red indicator turns off. For an invalid code, the red

indicator flashes.

4. With your device on, press CHANNEL UP. If the

device responds, no further programming is

required. Note: If some buttons do not operate your

equipment, try one of the other codes for your

brand.

Type Type stored Code

VCR

SAT

CBL

DVD

1 2 3 4 5 6 7 8 9 10 ... 22 23

Comentários a estes Manuais

Sem comentários

Zenith ZP505 Manual do Utilizador Página 5

Comentários a estes Manuais