Zenith PVR5269 Guia de Instalação descarregar pdf (Página 21)

UNIVERSAL REMOTE CONTROL

AUTO FIND OPTION

If you have tried all the codes listed for your brand and type of

product in the code table, and none of those codes operate your

equipment,you can use Auto Find to search for the code you need.

Follow these steps for each product you are using:

1. Turn the product ON and aim the remote toward it.

2. Press and hold PRG with a small blunt object until

the indicator lights (about three seconds).

3. Press the mode key on the remote for the product

you want to control: TV, VCR, CABLE, or AUX.

4. Key in code 0-0-0, then press ENTER within two

seconds. When the indicator light flashes three times

and remains lit, Auto Find is active.

Press and hold POWER, then release it, repeating

this action about once a second until the product

turns OFF.

Press ENTER immediately to save the code. If your

remote fails to operate the functions you use most

often, you can re-enter Auto Find and search for a

better code.

NOTES:

• The indicator light should flash OFF when you press

POWER and back ON when you release it. If the indicator

light stays on when you press POWER, Auto Find has tried

all available codes. If you finish Auto Find and the product

you want to control has not turned off, your remote cannot

control that product.

• Pressing PRG at any time during the use of Auto Find will

cancel Auto Find, and you will have to start again.

POWER I1_

OFF

Equipment to be

controlled

Typical Remote

Control

_23_1_ 4--5

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 97 98

Sem comentários

Zenith PVR5269 Guia de Instalação Página 21